Hello,

In latests version of Qimage Ultimate, the function "For new prints, add # copies" doesn't retain the number anymore.

In the past it used to retain until we change it. Now it keep returning back to 1 after adding an image.

I have a templates for school photos that has eleven times the same picture. Each time I select "add 11" and add the studient, it returns back to 1. It's time consuming and it is obvioulsy a bug that I didn't have last year.

Thanks in advance.
Philippe.

# copies doesn't change on its own.  If you change # copies to 11 and add an image, you get 11 prints of that image... and # copies stays set to 11.  Click the + on a different thumbnail and you now get 11 prints of that image too.  The only exception is a layout because # copies is part of the layout.

My bet is you are using a layout and you saved the layout with a "1" in the # copies.  In that case, whenever you get to a new page, it loads the layout again for the next page and it is loading the "1" stored inside the layout.

The solution: open the layout, change # copies to 11, and resave the layout.  # copies is a parameter stored in the layout for this very reason: so you can do packages and # copies is populated from the layout and set properly for that layout.

Regards,
Mike