Mike Chaney's Tech Corner

Mike's Software => Qimage => Topic started by: Iceman on June 04, 2009, 08:59:11 PM



Title: profiles
Post by: Iceman on June 04, 2009, 08:59:11 PM
I sent an e-mail a few days ago regarding profiles. The question was:
You do not show a D2Xs profile as available but you do have a D2X. Would that profile also apply to the D2Xs. Delving further into this matter, I also have a D2H and a profile is not available for that model. Would another profile work? Finally, a profile is not shown for the D3. Would it be reasonable to assume that the D700 profile would be useable for that body?
Thanks,
Bob


Title: Re: profiles
Post by: admin on June 04, 2009, 09:24:06 PM
I sent an e-mail a few days ago regarding profiles. The question was:
You do not show a D2Xs profile as available but you do have a D2X. Would that profile also apply to the D2Xs. Delving further into this matter, I also have a D2H and a profile is not available for that model. Would another profile work? Finally, a profile is not shown for the D3. Would it be reasonable to assume that the D700 profile would be useable for that body?
Thanks,
Bob

Never got that email.  To answer your question, I think the D2X profile would work well with the D2Xs.  I don't think there are any substitutions (that I would trust) on the D2H and D3.

Mike


Title: Re: profiles
Post by: Iceman on June 05, 2009, 03:41:03 AM
Thanks Mike,
You don't think that since the D3/d700 share the same sensor, the profile would work? I will order a D2x tomorrow.
Bob