The print stops part way without a message - paper ejects. There's an inch high block mid way across the span of the image. I thought this would have to do with memory.
Your advice is to choose Banner Roll and to NOT specify any length to the image, correct?

thank-you

The Epson 11880 printer aborted the printjob of 8 segments butted together to make a continuous image (each around 760mb 41859 pixels wide 6428 high).  Banner Roll was not selected. Does the Banner Roll option help prevent the driver from getting overloaded? Qimage is set to 720ppi - in my case; a  required setting. Thanks.

thank you, lenticular is tricky but I think Qimage U really provides a path for large scale.

best regards,
Billy 2

Hello, I'm trying to print a large print 52" x 65" at 720ppi on an Epson 11880 onto glossy paper at a flexible photo printer service. The project is a lenticular print; so, a high and consistent resolution is very important. I'm able to do this by slicing the image up in PS and segmenting it in QU as one print. I've had problems with the printer cutting out mid print with an older version of Qimage Ultimate (2014). I've seen in this forum recommendations to set the spooling settings to RAW, which I've done. Also in posts (from around 2010) that really large prints recommending printing at 360ppi. Can someone weigh in if this is still the case with version 2022 of QU? Also the indication that interpolating of lenticular prints to 1440ppi, would there be any theoretical limits to print size?

thanks for any thoughts and advice on using QU for large and high res printing.

B