Thanks Mike,  I did a few experiments making some obvious adjustments like converting to B&W and I now see Qimage is picking the changes up.  It did not appear that way before.  I was concerned Qimage was reading the old version file and not the new adjustment one.  Thanks for your response.

Lets say I export an image into Qimage.  After analyzing in Qimage I want to go back and make some adjustments in Lightroom.  What is the best way to update the Qimage cache images to reflect the changes in LR?

Thanks Mike,  I am still fairly new to Qimage and learning a lot.  With your tip I learned more today. I have watched many videos but have many more to go.  I never understood what the placement methods section was for but I do now.  It is very powerful

Using Qimage Ultimate version 2022.117 on Windows 10 64 bit.

Today the "print gap" section at the bottom of the Printers and Settings section just under the Canvas section disappeared completely from the program.  It was also missing in the full editor page.  I looked everywhere to see if there was a way to turn that section on and off but could not find anything.  It had been there previously.  Finally I did a complete reset of the program and it was back again.  Is there some setting to turn this section on and off?

Thanks Mike,  I have not been able to reproduce it on demand since it has happened randomly.  If no one else is mentioning it lets just table it for now.  I will continue to monitor it.

I was trying to figure out how to print a 5 X 7 print on a 5.5 X 8.5" paper (8.5 X 11 cut in half).  I was able to accomplish this in Lightroom no problem but I could not figure out how to do it in Qimage.  I finally came up with a configuration by creating a custom paper size (5.5 X 8.5), set the printer properties to borderless printing and adding a small top margin. Now I get a 5 X 7" print with margins all around.  Then I saved this custom print configuration.  I don't know if this is the best way but it works.  Remember I am still new to Qimage.  The error was occurring when I was working on this custom configuration and tried to switch to the full page editor.

No I did not load a job file.  I have never loaded a job file.  I am fairly new to Qimage and still figuring things out.  But I started fresh trying to configure a print.  I may have had several print sizes selected with the same image and I now see that each time I select a different size it creates an entry in the queue but I have never saved a job.  I have seen this error several times since I started using Qimage.
Is there a way to clear or reset the job file?

I am receiving the error "List Index Out of Bounds" when I open the full page editor page.  It does not happen every time I open this page.  When this happens Qimage Ultimate completely locks up and I have to end task.  No other option work.  I know you said this was corrected in version qu22-114P but I am still getting this error and lockup.

Here is the actual error logged in event viewer:
The program Qimage.exe version 2022.114.0.0 stopped interacting with Windows and was closed. To see if more information about the problem is available, check the problem history in the Security and Maintenance control panel.
 Process ID: 1cfc
 Start Time: 01d807c121f1aff1
 Termination Time: 4294967295
 Application Path: C:\Program Files (x86)\Qimage-U\Qimage.exe
 Report Id: 7d9c1bb3-b9be-4656-8601-abbb3473e65a
 Faulting package full name:
 Faulting package-relative application ID:
 Hang type: Top level window is idle