Fred,

Thanks for the information. I scanned the targets using vuescan raw mode with both scanners and the resulted images still have the same problem with the PP software. But based in your feedback, I think that if I answer "No" to the PP sotware I can use the image created with the Epson Scan program (48bit, tif).

Thanks again for your help.

Regards,
Wilfredo

Hello,

I bought the PP software about a week ago and I was trying to create some printer profiles with two different scanners. I read all the instructions but no matter what I do I still having problems with the scanned image and PP. I'm using Vuescan for the Canon MP980 and the Epson Scan software for the Epson Perfection V500. I used the recommended settings for the scanners.

When I open the image with the PP sotware a message appears asking to select yes or no. When I select yes, after cropping the printer target I always have more than 40 patches and a warning message. If I select "no" to the message I have perfect results. For what I understand from the instructions for a printer profile I need to always select "yes" to the message "Is this a 48 bit a linear (gamma 1.0) image and it is being used to profile a printer?".

I will appreciate if someone can clarify this point.

Thanks for the help.