I just calibrated my monitor. Could you please look at this attachment and tell me if I obtained good results according to this.
Also could you please tell me what it all means.
Thank you!

Nedd your help.
Just received U2410 monitor and it is calibrated at the factory as you can see from attached image. Also, Dell says that it cannot reproduce calibration data just in case.
Should I attempt to calibrate it with EZColor and OptixXR? I think that they used better equipment to calibrate it, than what I have. Affraid to mess up, even though I calibrated my Sony and CRT's before.
Advise please. Maybe Mike can say something here.
Thank you!

Also look at Dell U2410 ultrasharp.

I just bought U2410 from Dell. Look on line. Everyone raves about it. $ 532, if you open Dell acount. Couldn't find any better for my $$$
It is coming Wedensday 10/21.

I did reset in QI. Will test soon.

Thank you for your reply.
Where do I look, if my printer driver is set to reduce/enlarge?

These images didn't print as layout, if u look closely. The margins are wrong and images are shrunk compared to layout. They didn't print correctly in this respect.
Thanks!

more attachments. it says that I'm allowed to post 4 attachment 512KB total, but it then says that attachments exceed 256KB and won't post. BTW preview is slow or doesn't work?

follow up and attachments

I'm trying to print 2 images on 8x10 i lay them out as I want, but they don't print correctly. Am I doing something wrong, if so what?
Thank you!