Show Posts
|
Pages: [1]
|
1
|
Mike's Software / Qimage Ultimate / Re: v2017.104 issues/comments
|
on: October 12, 2016, 09:10:49 PM
|
I can't seem to get a print the size as entered. I enter the paper size and the custom print size and it shows up on the view normally, but it prints much smaller. example is a print entered as 16.25 inches comes out as 9 1/8 ". This just happened very recently; any chance it is due to the latest version 2017-104?
|
|
|
4
|
Technical Discussions / Printer Media / Re: B&W prints. Are they your cup of tea?
|
on: June 25, 2009, 09:50:42 PM
|
I have an Epson r2400 printer . I have tried a lot of different papers including the Gekko Green which was honored by some society ( can't remember which ) as the best bw paper on the market. I finally have settled on the Epson Exhibition Fiber as my favorite. I use the factory profile with the bw printing section of the printer driver and add 1red and 6 yellow to counteract the slight color cast and give it a slightly warm look---very subtle. Density is set to darker. By the way, I also consider it the best paper for color work. With any of the other papers, I got either a green or magenta cast which was impossible to compensate for. The results with the Epson paper give what I would consider a very neutral natural looking print, however there are times I would like to emulate the warm look of Portriga Rapid . I use Picture Window as an image program and I obtained from one of their contributors a curve to give the warm look of Portiga paper, but as far as I know that can't be used as a filter with Qimage; anyway I don't know how if it can be done. Anybody have any thoughts on this?
|
|
|
|