Hi Ray, Thanks for your response. Ok I'll tell you what I do and hopefully you can help. I go to user defined and make a custom page size. normally I make the size about a .25 inch larger than the page I need. In this case I made the custom size 24.02x10.75. The album page size is 20.5x10.5 which should fit the custom size with room to spare. I have tried a couple ways to print. The page loads in the queue fine, indicating in the view/print queue that my page is in fact 20.50x10.50. In the print properties I can either use original size or I have made a new size tool at my 20.50x10.50 and after printing I am about a 1/4 inch short on all sides. I'm not sure what else to do. Perhaps you could give me a step by step on what you would do. It would be much appreciated as I am at wits end. I am printing on 24in roll paper. I hope I have explained enough. If not please ask more
I need to resolve this. I have a lot of jobs to get done. I haven't set any boarders that I know of.
Thanks very much,
Glenn