Show Posts
|
Pages: 1 [2] 3 4 ... 6
|
16
|
Mike's Software / Qimage Ultimate / Re: v2022.100 issues/comments
|
on: August 20, 2021, 05:30:34 PM
|
Mike, the size of the text in the ‘floating text properties’, that is in the box under ‘enter your text below’, does not seem to change as UI size is increased. Do I need to change text size some other place? On 4K monitor, it is real small.
|
|
|
19
|
Mike's Software / Qimage Ultimate Wish List / Re: Working with Super Resolution DNG created by ACR 3.2
|
on: March 21, 2021, 04:40:39 PM
|
The 'enhanced' .dng file is the same as any other .dng file, and will open in QImage in exactly the same way as anything other raw file.
Brian P
If other adjustments were made to the dng, either in ACR or LR, Qimage would not recognize them. That was why I suggested a TIFF. Unless Qimage was going to be used as the sole processor of the raw file.
|
|
|
22
|
Mike's Software / Qimage Ultimate / Re: Printing multiple postcards on one sheet...
|
on: August 14, 2020, 04:26:48 PM
|
If you just want to center the whole image on both sides, use IntelliCenter since that will center the image on the physical paper. You could enable the print preview in the driver to confirm placement before you actually print.
Regards, Mike
Mike, I know you do not like to tell people what to do. However, would it be easier for the OP to just use one image/text and use Qimage placement functions?
|
|
|
25
|
Mike's Software / Qimage Ultimate / Re: Center on page not printable
|
on: August 28, 2019, 04:33:52 AM
|
Mike,
‘Template/centered’ butts the 5x7 together at center of page. ‘Intellicenter’ Center’s it on the page, but puts a “gutter” between the images. The point of what I am doing is to fold into a card and have the one face be a borderless picture.
Is there an adjustment I am missing?
|
|
|
26
|
Mike's Software / Qimage Ultimate / Center on page not printable
|
on: August 26, 2019, 09:31:31 PM
|
Creating a template to print 7 x 10 cards on 8.5” x 11” paper. Using Canon 1000Pro, which has trailing edge unprintable area wider than leading edge.
Using ‘Template/Centered’, it gets close to center, but is about 1/16 off (Qimage screen shows center at 5 7/16). Printed page shows same measurement.
What am I missing?
|
|
|
30
|
Mike's Software / Qimage Ultimate / Create uneven border - filling unknown width
|
on: July 30, 2019, 09:07:16 PM
|
I have, say, an approx. 1:2 aspect image. I want to print to a 4:5 aspect (16” x 20”). I would like a 0.5” border mat on the sides of the long edge, but do not know the exact space to fill on the short (top and bottom) edges.
Is there a way to do this (using ‘photo mat’?) without manually calculating the space? That is, automatically fill the open space remaining above/below the image.
|
|
|
|