Show Posts
|
Pages: [1]
|
2
|
Mike's Software / Qimage / Re: help with print size
|
on: April 10, 2010, 01:27:09 AM
|
Thanks for responding....the queue says image#.tiff<8x10, nothing about borders. What I did notice in my printer driver 'reduce/enlarge' was checked and has 2 options....'fit to page' and 'custom' with scaling which I can set to 100%, is this what you'retalking about ? I can also just turn off 'reduce/enlarge' altogether.....
ok I just reset the scaling to 100%, I think this was the problem, I'll try a print in the am, I'll either be 'smilin' or 'cryin'.....let you know....and okey dokey on the hybrid interpolation
|
|
|
3
|
Mike's Software / Qimage / help with print size
|
on: April 09, 2010, 09:59:51 PM
|
just got back into using qimage and am a bit frustrated. I just set all my printer properties as per the documentation for an epson 4880, centered on, borderless off, highest quality...etc, saved as custom setup.
main page printer props.....paper setings....source - paper tray...size - 8.5x11....printable area - centered.....borderless unchecked
page layout...got the ouput page right, shows up as 8.5 x 11 in qimage
cropped in qimage using pryramid interpolation to 8x10...and the print comes out 7x9....what am I missing ?
Thanks
|
|
|
|