Show Posts
|
Pages: 1 [2]
|
16
|
Technical Discussions / Computer Hardware / Re: Colormunki
|
on: May 03, 2010, 11:16:55 PM
|
Hello, I used the Eye One 2 first time in my life and my first results were far away from what I read on the forum. For the U2410 in Advanced mode, after I adjusted contract to 69, brightness reached only 59. When I tried again, though the contract changed slightly, the brightness was still less than half of 120 (59) even though I top it up to 100%. For these two tests I used 6500 settings. When I tried Native White Point, the number was higher and almost reached 120, but then was sliding down and stabilized at around 103. After I proceeded to the end of the calibration the final report showed 130! I am reading the forum to find answers. Perhaps I am doing something wrong as I have no experience with any calorimeters. For example, after I read the tutorial, I am not sure if I have to do the Eye One 2 calibration (on a black non-reflective surface). So far, I certainly see that I need more knowledge about how to calibrate properly using this calorimeter. Best wishes, Roma
|
|
|
18
|
Technical Discussions / Computer Hardware / Re: Colormunki
|
on: May 03, 2010, 05:23:44 PM
|
Hello Terri,
Do you think Eye One 2 is a good calorimeter? I have purchased it, but first time I used it on U2410 I could not get any normal results. I trust that the colorimeter works fine.
Please advise.
Roma
|
|
|
19
|
Technical Discussions / Computer Hardware / Re: Dell U2410 calibration
|
on: May 03, 2010, 05:20:21 PM
|
Hello,
I am new to the forum and have just registered to share my concerns about the U2410 monitor. I got it about 10 days ago, I also purchased Eye One 2 to calibrate it. As I can see, Terry has the same calibrator and his results are excellent. My results were disaster. Basically on both Normal White mode and 6500 I never was able to reach luminence close to 120 even at 100 brightness. I will post more details later. However, I believe that this could be a monitor issue rather than the calibrator problem, which is a brand new.
I will read the whole forum again and look at the calibration results when I am home. Any advice would be greatly appreciated as my experience with monitors calibration is next to nothing. Thank you in advance,
Roma
|
|
|
|