Looks like "Print Image with Actual Size" is the setting I can live with. It gives me a 1/10" edge on the right side of the rolls, but at least it doesn't crop into the print as it did before (see attached).
Thanks Fred and everyone, you've been a big help.
Regards,
Stan

Terry, I disabled the overspray feature and tried it in a trial version of QU, still having the same problem.
Stan

I had set up the paper as 10" by the length I was needing for the number of prints needed, i.e., 32".
I set up the paper as 10.02" and it made it worse. I went the other way with 9.97" wide and that didn't work either. It's the same in Ultimate also.

When it's ready to print in the Canon driver, the option "Center Originals Across Roll" is grayed out and doesn't let me click on it. That should correct the problem, but it's not letting me click it ??

Frustrating that something so straightforward as placing 2 5x7s across a 10 inch wide page doesn't work the way it should.

Thanks again Fred

Thanks for you reply Fred.

I just can't understand why both prints aren't printed evenly across the page, but one is cropped more than the other (see attached image), it's not a matter of leaving a slight white border around the edge of the prints, but printing too far over the right edge of the print, there should be a more accurate adjustment to correct off-center prints.

 I may have to combine 2 5x7s in Photoshop and print 8x10s to take care of the problem.
Stan

I've been printing 5x7s 2 across on 10 inch rolls with the ipf 8300 printer but the 5x7s printing on the right side have been printing cropped into the bottom of the print about 1/8" in addition to cropping the image approx 7/16 ", i.e., cutting into the fee of a group photo and into the logo area.
The prints coming off the printer on the left side are being cropped about 1/8" off the top

I've been using the compact or optimal settings along with auto crop and standard crop and borderless.
It is printing full bleed to the edge of the paper with not white border. I've tried several other settings, but I haven't been able to correct the situation.

Hope someone can help.
Thanks
Stan