That makes sense now, not all the images will be the same size but that shouldn't matter. Can you not just add a boarder to the bottom of the image and not the whole of it?

If the image is 20.2"x20.2", Qimage wil not change that will it? Will it just add the boarder to it?

Sorry for all the questions, it will make more sense once I have bought it.

Another question, I'm printing on a 24" roll. If I add the boarder to a 20x20" print, that will exceed the roll width, will it add the boarder to all sides? If it does, will that effect print?

So the B selection wouldn't resize the image. I crop it in PS with a 2mm overhang to go around the edge, would qimage change that?

Think that makes sense, I haven't bought it yet I just want to make sure Qimage can do it.

Will I have to setup the boarder for every image or can it be automated?

Do you have to set a paper size in Qimage or is that automatic?

Thanks for the advice.

I use an epson 7880 and photoshop to edit me images.

I print photos onto canvas so the images are never the same size. The problem I have is not being able to print them fast enough. I have to manually reset the printer every time a print has finished, if I have 20 images waiting to be printed this takes up a lot of my time. If I'm dealing with a customer I forget to send an image to print, which is more time lost. Is there a way to stack the images so they print one after another?

The image needs to have a 6" cap to the next image, this leaves enough white canvas to stretch around the bars when cut off the roll. Is it possible to set this up in Qimage so every image printed has that gap?

I want to be able to press print and all 20 image print with the correct gap and not need to reset the printer every time. Could Qimage do this and would it save me any time?

Hope that all makes sense. Any help would be much appreciated.