Thank you so much, I was about to pull out my last 2 hairs.

I printed some gallery wraps ,adding extra for the canvas size, and now I cannot get that turned off,. when I place an image in queue it automatically adds mirror image for the wrap. How do you reset that .I am in a time bind for a customer. I have attached a screen capture

I have 4 drives on my computer but I can only access 2 because the others don't show

Just figured it out. I had pulled the image from a web file instead of the one showing in Qimage, really feel ignorant sometimes. Thanks for the reply. God bless and have a wonderful and happy Thanksgiving.

Hey Fred,
The images are JPG. I saw the problem, went to CS4, opened the image from Bridge, corrected it,closed and saved changes. I have done this before with no problems. Just can't figure it out.

I was printing some images and discovered a few problems, corrected them in CS4, saved them and then used the refresh thumbs, but they don't change. I have tried several times. Help

Thanks but I found the problem, while waiting for an answer. I had selected landscape, while at the same time selecting the 24x30 paper size and I guess it just tried to compensate. They looked fine in the preview, which I should have looked just a bit further.

I was using a 24x30 paper size set to portrait, to nest several images, when it printed they were all distorted, stretched along the long side of the paper. Any suggestions?

thank you very much, that was the problem. I really appreciate your response. God bless and keep you.

For some unknown reason I am not able to access the soft proof function in the editor window. Any Ideas?

I have ask this question before on yahoo groups, but didn't really get any way to work it out.
The problem is I have a hp z3100 and using 24 inch paper, I have created a 11x24 page(for ease of handling in the cutter), but would like to be able to put more than one predefined layout on the page. When I try this it automatically creates a second page, which is a pain. feeding 8x10 sheets on this is out of the question. I don't have an 11inch roll either but probably should. Are there any work arounds, I have tried creating my own layouts but it is such a hassle to get the little boxes all lined up.

Mike thanks for the new forum.
I have a z3100 and for the most part i can work around the weirdness and compatibility issues. I saw here where Ernst has told of a updated driver and firmware, and I am very reticent to load them. The last firmware upgrade fried the hard drive and the printer and now that my warranty is gone and I didn't have the funds to extend it I just don't know that it will benefit me enough to warrant the chance of a major issue as before. I have just come from a month long trip and the printer performed flawlessly. so unless someone can convince me it is worth the gamble here I stand.
As a side note I don't know what I would do without a product like Qimage.