Just installed 2016.110. My hardware is Del XPS15 with 15inch monitor res 3840x2088. The pixels are TINY, and on windows 8.1, setting the system magnification to 200% gives a useable effect - big enough to read, but sill get enough things on the screen side by side to be useful.
The UI changes in 2016.110 means that QI is also now useable on this PC at full res.
There remain one or two issues, most concerned with vertical headroom. I have attached a screenshotwith the UI set at 200%. I have one at 250% UI for comparison, but can't load it here because of size restriction..
- The title bar seems to enlarge just enough to hold the Qimage version, but not the same size as other 'unskinned' windows - so the buttons to minimize, restore, maximize, close etc at the right hand end are still minute as a target for clicking.
- The window which describes the skin and font in use clips the font at the top.
- The window that describes the paper in the printer and its resolution is too small.
- The window that displays the heading "Job Properties" is too small.
- The description "[Template]" needs attention.
2016.110 is a great start. Microsoft sure haven't made this easy!