Hi Fred, thanks for the reply and great information. As an example of a cushion I'm trying to print: My total fabric size is 40cm x 1m. (15.7"x39.4")
.7 The main image is 40cm x 40cm (15.7x15.7") positioned at the top of the fabric which will cover the front of the cushion. However I need to have enough blank fabric on the template to be the back of the cushion cover and put my logo on the edge at the bottom so that when it is all folded and stitched together my logo is on the rear of the cushion. My media roll is 44 inches wide and I'm not sure how to position my template on it so that I can minimise wasting fabric. It would be ideal if I could position the template to print across the media rather than vertically. Thanks for your help, Eamon

Hi, iv just purchased an Epson stylus pro 9880 printer [2nd hand] which has come with a few partially used rolls of media. These rolls are un named. Afew have numbers inside but that's about it. Is there a way of finding out which one is what as iv been told its quite important to know which media is being used both for quality of printing and of course so I can log the details in the printer driver/setup. I have photos of the 3 rolls [close up pics] if anyone is experienced enough to have a look that would be great..

Hi. I'm looking for advice on how to set up an image as to know where it is going to print on my media. For example, if I want to print an image on the end of my media roll on the right hand side how would I set this up? Also I would like to print to fabric to make cushion covers, again I have the problem of not knowing where I'm printing. If I was to print my image lets say 50cm by 50cm (19.7x19.7") than leave 70cm (27.6") of fabric than print my business logo how would I set this up?? thanks for any help.