Thanks Mike.
As you have correctly explained, the internal margin is easy enough to fix.

What I really need right for the application I have in mind is really a centered printing, which at this point is not available in Qimage.
And Thank you Terry as well.

I did think about cropping, but in this application that is not acceptable either alas.
I will need to decide if I want to do the super-tedious split by hand or what.

Thank you for your answers.
Marco.

Mike, I still can not get the print centered in the virtual page.

The first image attached shows the Qimage setup, the second one the print result.
This was a 2x2 print, the top print is bottom right, the bottom print is bottom left.

What I would like to have is a situation where the print would be centered horizontally on the virtual page, so that it would be possible to create a multi-pane installation directly without page-trimming.

That's why I was asking if it could be added as a feature the definition of the internal margin.


Thanks, Marco.





And this is the result:

Thanks Mike.
I'll try again making sure I doublecheck all the settings.

Marco.

Dear all,
Hope is not a repeat of a post in the old yahoo group.
I did a few searches but could not find this one.

When I select a poster I have understood that I should use
Margin 1 for the margin to be applied on each page being printed

However, I have been unable, so far, to have Qimage to print the image centered in the TOTAL resulting page.
So if I'm telling QIMG to print on a 3x3, I'd like the image to be centered with respect to the virtual 3x3 page.
Alas I have not yet been capable of doing it.

Is it possible ?

It would also be greate (or I could not find it) If there was a preview that showed (even in low quality) how the picture will be split.

Thank you.
Marco.