trouble printing 17x22 thru qimage to my epson 3800.  i am using vmware fusion/quimage on macbook pro.  8x10 print perfect and in 15seconds but 17x22 setup puts the image cropped and cut off and in quadrant.  if i choose to print say a 3x5 center'd on 17x22 paper, it slightly centers it but it is again cropped.  the viewing looks perfect as to placement on screen with qimage soft proof etc but after you hit print it prints to paper incorrectly (which takes up to 20 minutes for 17x22).

HELP

Sounds like the settings are off in the print driver. Check Scaling and stuff like that.
I just experimented with the driver, and scaling will do just about what you describe. Then doing a HELP and RESET Printer from Qimage will fix it.
Fred

I can see what is happening, but I don't have the manual or the printer, just the driver.
When I select 17 x 22 paper, the output automatically grays out the 17 x 22, and substitutes a smaller size; input paper feed is set to Manual Front.
See screen snap 20 of Manual Front paper feed. You can see the paper size shows 17 x 22 to 8.5 x 11.

If I change the paper feed point to Manual Rear, then I get what you see in snap 21.
Then I get 17 x 22 to 17 x 22, indicating that it seems to be accepting and keeping the 17 x 22 paper size.
Have a try changing the feed and see what happens.
Must be someone out there with a 3800 and 17 x 22 paper to test this.

Fred

thank you for the info.  vmware is fusion.  with 8 gig of ram, i have increased the memory from 2 to 5 and still i can't print to 17x22 paper.  it takes about 30minutes for a "fit to page" and when it prints it is cropped/segment and off center.  letter size works perfectly and prints in 8-10 seconds.  out of straight photoshop (mac) i can print to any size with no problem, errrrrrr

thank you for your responses.  i have reviewed your attachments and config mine as well.  still nothing positive.  side note, in qimage can you explain how to open windows for print and job properties (i reset memory etc and now when i launch those two windows are not available to open?)  thanx so much

again ty but my bar is not highlited blue (as it once was) it is clear so expanding and collapsing now is not available, any ideas?

I think I would go to HELP in Qimage and click on RESET all Program Settings.
If you still have a screen problem after that, I would look at video memory or your graphics  card.
You made some change to Windows memory configuration; maybe put that back???

Fred

You say that you tried front load setting and rear load setting and neither allowed 17 x 22?

See attached screen snap.
Can you manage to try your settings this way? I made a 15 x 20 print all the way to print preview (turned on in driver), and it looks like a winner!

Fred