Hi Fred - Good to see you here. I'm using an Epson R2880. I've used Q to print hundreds of images with this printer - but I haven't needed to print borderless for a very long time. Printer settings in the Printer Setup dialog, accessed through Q, are Size=4X6 in - Source=Sheet (borderless) - Orientation=Portrait (and rotate the image in Q as required) - then the several color management settings, which I don't think apply to the print size.
I think I'm going wrong somewhere on the Edit screen of Qimage, and most likely in the Image Effects box of that screen, where I'm trying to force Q to print at size 4.0X5.33 but it always defaults back to 3.4X4.50
Bill
Ok Bill, Good to talk again.
This is pretty straight forward.
I happened to have some S 100 images and the 2880 driver.
Apparently, you want no cropping at all, just fill the sides.
OK, In the driver you selected 4 x 6 paper and Borderless is checked. That produces a printable area on the 4x6 paper of 4.0 x 6.0.
You find that located above the preview panel, upper right of the screen.
Add your image, crop scissors OFF, and select Fit to page as your size selection.
Your print size will be 4.00 x 5.31. That is as large as you can print without cropping on a 4 x 6 paper with an S 100 image (which has not been cropped earlier)
So there are only two pot holes that could trip you up.
1) The images *were* cropped in the editor, and no longer have the aspect ratio 4:3 that the original image has, so with crop scissor off you would get varying sizes.
2) In the driver, you might have meddled with some setting in the Layout screen. See attached.
No checkmarks in Reduce/Enlarge.... and make sure OUTPUT still says, SAME AS PAPER SIZE.
I'll stop here and see how you are doing.
Fred
Qimage registration expired? New lifetime licenses are only $59.99!
