|
Title: Increasing the Density/Thickness of Printed Fold Marks Post by: Geomick on January 25, 2025, 11:19:02 PM G'day Mike,
I print loads of canvases, and the vast majority I setup with mirrored edges, and I also print the Fold Marks to make life easier when stretching them. But the weight of canvas that I use makes it quite difficult to see the stroke of the Fold Line through to the reverse side when I'm positioning the stretcher frame. I often use a small torch to shine the printed line through which helps a little, but I would really prefer to give the Fold Marks a greater Line Weight (ie: thicker and darker) to make it easier to locate from the rear of the canvas. Is a parameter that I can change anywhere? Many thanks. Title: Re: Increasing the Density/Thickness of Printed Fold Marks Post by: admin on January 26, 2025, 01:23:44 PM Good idea! I'll see what I can do.
Regards, Mike Title: Re: Increasing the Density/Thickness of Printed Fold Marks Post by: admin on January 29, 2025, 03:55:52 PM 2025.101 will have thicker fold marks to make visibility from the back of the canvas easier. Due out in a week or so.
Mike Title: Re: Increasing the Density/Thickness of Printed Fold Marks Post by: admin on January 31, 2025, 10:00:42 PM Completed: includeded in today's 2025.101 release.
Regards, Mike |