Using Qimage Ultimate version 2022.117 on Windows 10 64 bit.

Today the "print gap" section at the bottom of the Printers and Settings section just under the Canvas section disappeared completely from the program.  It was also missing in the full editor page.  I looked everywhere to see if there was a way to turn that section on and off but could not find anything.  It had been there previously.  Finally I did a complete reset of the program and it was back again.  Is there some setting to turn this section on and off?

Thanks Mike,  I am still fairly new to Qimage and learning a lot.  With your tip I learned more today. I have watched many videos but have many more to go.  I never understood what the placement methods section was for but I do now.  It is very powerful