|
Title: Center on page not printable Post by: jrsforums on August 26, 2019, 09:31:31 PM Creating a template to print 7 x 10 cards on 8.5” x 11” paper. Using Canon 1000Pro, which has trailing edge unprintable area wider than leading edge.
Using ‘Template/Centered’, it gets close to center, but is about 1/16 off (Qimage screen shows center at 5 7/16). Printed page shows same measurement. What am I missing? Title: Re: Center on page not printable Post by: admin on August 27, 2019, 06:09:58 AM Try IntelliCenter instead of Template-Centered. All "Intelli" methods center on the physical page while the other options center within the printable area.
Regards, Mike Title: Re: Center on page not printable Post by: jrsforums on August 28, 2019, 04:33:52 AM Mike,
‘Template/centered’ butts the 5x7 together at center of page. ‘Intellicenter’ Center’s it on the page, but puts a “gutter” between the images. The point of what I am doing is to fold into a card and have the one face be a borderless picture. Is there an adjustment I am missing? Title: Re: Center on page not printable Post by: MelW on August 28, 2019, 01:32:29 PM Whenever I have done anything like this - which I admit has been seldom - I found it best to use freehand placement. Use the page editor to micro-position each photo - then - just as a double check - run a print preview.
Title: Re: Center on page not printable Post by: admin on August 28, 2019, 02:59:52 PM Yeah, I misunderstood that you wanted a 7x10 on an 8.5x11 page. If you are arranging two prints on two halves of the page, I would just create a layout in freehand mode. Add two templates of the size you want and place them manually/precisely in the full page editor by using the location tab and entering the precise locations. Then save the layout and you can use it any time.
Regards, Mike |