A simple question here that I have failed to find the answer to. How do I move an image, that is the only image on the last page of many, back a page, when the I know the previous page has space for it. I would assume that Sort would do this, and it usually does a good job. But sometimes I am left in the predicament above where I will be using a sheet of expensive paper extra where I didn't need to.
Not sure exactly what you are doing, but try this:
On the last page where you have a single image, in the Page Editor, Right click and use CUT.
Then go back to the page on which you want to place the image and in the editor again, use PASTE.
You might have click the RED F for Freehand mode on the page on which to paste.
Fred
Just got in.. and had a few minutes.
SORT command works fine too
That's easier than Cut and Paste.
Qimage registration expired? New lifetime licenses are only $59.99!
