Mike Chaney's Tech Corner
December 26, 2024, 02:53:40 PM *
Welcome, Guest. Please login or register.
Did you miss your activation email?

Login with username, password and session length
News: Qimage registration expired? New lifetime licenses are only $59.99!
 
   Home   Help Login Register  
Mike Chaney's Tech Corner > Mike's Software > Qimage Ultimate > Number keeps recycling
Pages: [1]
« previous next »
  Print  
Author Topic: Number keeps recycling  (Read 4919 times)
sync007
Full Member
***
Posts: 126


Email
« on: July 06, 2020, 11:19:52 PM »
I have a 16x20 sheet set up with 18 images on it and when I save it either as a job or session the number just keep recycling over and over again and never ends. It hung up and I had to go to task and kill the program then start all over and tried it again and still the same thing happens? Screen grab attached, the area shows the number that keeps changing
Logged
admin
Administrator
Forum Superhero
*****
Posts: 4229



Email
« Reply #1 on: July 07, 2020, 05:04:44 AM »
It is showing you all 15 images from the job that is selected.  It is cycling through the images in the selected job so you can see what is in the job.  There shouldn't be any task you need to kill.  You could ignore that if you like: the dialog should act like any other dialog and when you click Save or Cancel, the dialog will close.

Regards,
Mike
Logged
sync007
Full Member
***
Posts: 126


Email
« Reply #2 on: July 07, 2020, 02:09:12 PM »
Ok but it starts at 1 then goes to 15 then starts again at 1 and goes to 15 and again and again never stops?
Logged
admin
Administrator
Forum Superhero
*****
Posts: 4229



Email
« Reply #3 on: July 07, 2020, 02:28:07 PM »
Right.  It cycles through the images so you can see the images in the selected job.  It has no effect on use of the dialog.

Regards,
Mike
Logged
sync007
Full Member
***
Posts: 126


Email
« Reply #4 on: July 07, 2020, 03:56:12 PM »
I would have thought it would go through the 15 to show you and then stop, but ok.

By the way what's the fastest way to open a session, I create a few of them and recall is what I have been using?
Logged
admin
Administrator
Forum Superhero
*****
Posts: 4229



Email
« Reply #5 on: July 07, 2020, 04:20:03 PM »
There's really no reason to stop on any particular image since it's a job preview: it cycles because you may have not noticed/seen a particular image on the first cycle.

The fastest way to load something like a session would be to click the recall button up top, so it sounds like you are already doing that.

Mike
Logged
Pages: [1]
  Print  
« previous next »
 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Valid XHTML 1.0! Valid CSS!
Security updates 2022 by ddisoftware, Inc.