Hi,
When I transfer a file with a given resolution, in PPI, to Qimage, will in 'tab' Printers and Settings, part -> 'Processing', setting a 'Print Res', Qimage Ultimate alter the data to a (chosen)default value before sending it to the printer?

Hi Fred,
As always I make the (stupid) mistake. Of course I meant the file resolution in PPI..

with regards, Martin.

Hi Fred,

So if a given file has a given resolution in DPI, Qimage calculates the factor needed to get the desired resolution in PPI. "
Using: "Printer and Settings" -> "Processing" -> setting: Print Res: XXX

regards, Martin

PPI makes no sense for photos: photos just have a certain number of pixels and you don't know how big you want to print them until print time.

Scans, logos, art designs, etc. could have PPI only for the purpose of telling you what size is the preferred size for that image.  You scan an 8x10 photo at 300 PPI and you get an image that is 2400x3000 pixels and it is labelled 300 PPI so that you can print that 2400x3000 pixel image at 300 PPI and get an 8x10 reproduction of the 8x10 scan.  In Qimage, you use "Original Size" if you want a copy of a scanned image at the size it was scanned (the PPI listed in the file).

Other than the above example of scanned documents, logos, and things where you want to know what size the original was, Qimage doesn't care.  It's going to take every image and interpolate it to the PPI of the printer (driver) at print time anyway: usually 720 PPI for Epsons and 600 for everything else.

Regards,
Mike