Floating text and borders are print (layout) features: they do not belong to the image as they are not image edits.  Use print to file: drop down the printer selection and select "Print to File" and set up your page/output preferences.  Then when you print, it'll create files of each page.

Regards,
Mike

To put into a pictures folder in case I want to print it later but Mike has said just to save it as a job but if I need to save just the file as a jpg or tiff do a print to file

Just make sure your print to file parameters (paper size) is correct.  It sounds like you selected a paper size that is too small.

Mike

Did you use a B+ border which would have made your print larger?  I can't tell anything without screenshots.  Just post a screenshot of what you are seeing.

Mike

Here is the second shot

This is kind of all over the place.  I can't really tell what is going on.  First I have one small corner of the live view showing where something looks cut off, but I have no context: the rest of the screen showing important parameters is missing.  Then I have the print to file setup showing 18x24 page size.  And finally a screen shot showing a 19.7 x 29 page size?  Where did that come from?  Where did you get a 19+ x 29+ page size?  Basically I have no idea of your sequence and how you got to these results.

If you set up your print to file page size as 18x24 and you add a print at 18x24 (or smaller), there will be nothing cut off.  If you add your border afterward, just make sure you don't use a B+ border which will expand the print size.

For me to see what is going on, I need a sequence showing what you are doing and I have to see the whole screen so I can see how it is set up.  If the forum image size limitation is stopping you, just upload them to Google Drive or something and give a link.  What would be even better is a screen recording/screen cast showing what you are doing in video form, but if you can't do that, I at least need to see the screen shot of the whole Qimage window where the border is getting cut off.

Bottom line: for anything to get cut off, either you've done something to make your print size bigger than 18x24... or your page size is smaller than 18x24.

Mike

Thanks.  Now I can see.  You are loading a job for the Pro-2100 printer which has its own parameters for that printer.  You are then trying to adapt that job to print-to-file and some things aren't translating between Pro-2100 and your print-to-file setup.  The main problem here is that you are going from a 19.763 x 29.763 page size (from your Pro-2100 job you are loading) down to an 18 x 24 page size and you have Freehand page turned on in that job you loaded!  Notice where your print is located on the page before you go to print-to-file: your print spans from the 1 inch mark to the 19 inch mark (and there is no 19 inch mark on your 18 x 24 page).  Qimage isn't allowed to move the print because the page is in freehand mode, so the right side is off the page.

To correct, before you switch to print-to-file mode, click the little hand button on the lower left of your sreencast to turn Freehand page off.  That will allow Qimage to move the print as necessary to conform to your smaller 18 x 24 page size.

Or... if you want the printed page to look exactly like your Pro-2100 page, at 38 seconds in your video, click the printer button on the top right of the print-to-file dialog.  That will set up the print-to-file page size the same as the current page size (which in your case is 19.763 x 29.763).  Then your print-to-file page size will be the same as what is currently in place from your Pro-2100 job and there will be no scaling or moving necessary.

Mike