Size printed problem

pil91

Newbie

Posts: 8

« on: October 04, 2022, 05:32:11 PM »

New with Qimage that I test, I thought I had made correct settings, from the screen display everything looked good.
But the printed result does not match the screen.
The print is only 416 mm for 420 mm.

In attachment I have provided my settings.
What could be the problem.
Thank you in advance for your help.


	Logged

admin

Administrator
Forum Superhero

Posts: 4219

Re: Size printed problem

« Reply #1 on: October 04, 2022, 07:20:59 PM »

I can't really tell what we're looking at here. Your PDF shows little chopped up slivers of fractions of the live view. Your image seems to have a white border so your arrow and circle essentially point to nothing: I can't see where the true edge of the print is.

Rulers aren't the best way to tell the size of the print. Hold your mouse over the print on the live view and read what size Qimage is reporting for the print: that is the exact size that is sent to the driver.

Regards,
Mike


	Logged

pil91

Newbie

Posts: 8

Re: Size printed problem

« Reply #2 on: October 05, 2022, 08:17:20 AM »

Thank you Mike for your reply.
Here is as attached file.
Hard copy full page

Job details from the log

Code:

This file is a Qimage print job.
A print job contains all information necessary to restore Qimage to a certain "state" including all images in the
queue and all settings such as page size, paper type, printer profile, margins, etc.

* Qimage v2023.103
* Printing to: EPSONFD184E (SC-P800 Series)
* Page 1/1: 430.0 x 604.0 mm.  (720 x 720)
* Printer ICC profile: SC-P800 Series Epson Premium Semigloss (RC, BPC)
* Interpolation: Max-720 PPI/Max-720 PPI/Forge
* Print sharpening: On
* Global filter: Off
* Print filter: Off
* Canvas shrinkage comp: 0.00
* Copies of each page: 1
* Job started: N/A (saved job)
* Job finished: N/A (saved job)
1,D:\Temp\the lion king.jpg,420.0,594.0


	Logged

admin

Administrator
Forum Superhero

Posts: 4219

Re: Size printed problem

« Reply #3 on: October 05, 2022, 11:21:38 AM »

Looks like you are using borderless and your print is jammed in the top left corner. You are probably losing a few millimeters due to paper feed and the fact that the printer cannot load paper with such precision that the top and left edges shown are exactly on the edge of the paper. Switch to IntelliCenter so that the print is centered on the page to give it a little slack. No printer is going to be precise enough (in paper loading) to be able to print exactly to the edges.

Regards,
Mike


	Logged

Pages: [1]

« previous next »