Do i only get 1 attempt at Prints-choosing the print sizes? Because the 1st attempt will show a yellow highlight around Fit to Page (because i chose it). Then when I choose another size i would lose the yellow highlight and never get the yellow highlight back. Even if i click on Fit to Page again nothing shows that I have chosen it......
From then onwards i'm flying blind as to which sizing I have now engaged.
I very much prefer the way QImage worked in v 2017. I'm always getting my panties into knots working with the v2018 version.
This is very simple, but not easy to explain so bear with me.
The screen has an operational left side, and an operational right side.
Certain items depend on what is being called for.
There is a yellow dot/ball above the active side that alerts you to what is active.
See screen snaps 119 and 120. Yellow ball on right above the middle screen, and yellow ball above the thumbs.
If the thumb side is active, the yellow highlighted sizes will always be there regardless of how many changes you make.
Qimage assumes that with the thumb side active, you want to add an image to the queue at a certain print size.
You even have two control dots, lower right that allows you to choose what the size selection should do; add another image at a new specified size, or resize the selected image.
Yet, there's a simple way to know what size is currently the working size. Roll your mouse cursor over the empty main print screen, and a large label pops out to remind you.
See snap 117 for the label and 118 to show no yellow highlight at that moment.
Fred
Qimage registration expired? New lifetime licenses are only $59.99!
