Excuse me, if this has already came through, but I don't think it did.
Earlier this week I set up 2 cards in photoshop, 10x6.75, to fit paper and envelopes.  I set up 1 horizinal and one veritical.  I went into QI and printed both beautifully.  I even saved the job settings to recall in QI.  This morning I tried setting up another card in PhotoShop, by just overlaying a new painting over the previous one in a new layer.  Now every one prints with the top of the painting cut off, even the cards that printed beautifully earlier in the week.  I've tried fit to page, and original size, as well as the custom size 10x6.75 set up earlier that worked before.  I've also tried crop on and off.  I've exhausted myself and my limited knowledge.  Could some please check out the screen print sent seperately, and help me find out what dumb thing I have done??

Many thanks,
Betty

Fred, thanks for reading and trying.  I did the printer reset, still same resulting cutting off of the top.
Betty

Thanks again, Fred.  I had to leave and go to my grandson's ball game. 
I'm attaching screen prints of the page editor and also a different screen shot showing settings better of QI.

I'm at a loss here.

Betty

Betty,
Thank you for the screen snaps, but I need you to define the problem according to the screen snaps I see.
There is a painting of flowers, three flowers.
When you make your print, what goes wrong?
The top of the flower is cut off or is the print cut off with the flower painting no longer central?
What happens?
Fred

Betty,
The 2 x2 in red is caused by you telling Qimage to make a print that will not fit on teh paper size.
It is saying, "hey, if you really want that size print, I need 4 sheets of paper."

So recheck your 6.75 x 10 print size.
What was the actual size of the print that came out of your printer? Can you measure it with a ruler?
What you describe, Assuming that Qimage is still reporting in the lower left quadrant, a print size of 10 x 6.75, is a printer driver problem where something is scaling, zooming or enlarging the print.

Can you make a jpg of the psd file and email to me? wathree.ssz@verizon.net

Fred

Betty,
Have another look at the rulers in Qimage and you will see that it is still showing 6.75.
Look at the start of the image. It is starting (based on position on the page) just shy of the 1" mark, looks like about .88 inches as per the readout to the right side.
So all you do is read the difference from the beginning of the image to the lower end of the image, and you see 6.75 inches between the start and the end.

Also, you can see that (on the right) it shows. .88 above the image, a 6.75 inch image height, and .88 below.
Add them up and you have the paper size.

One last item, that needs to be mentioned.
When I asked that you click HELP and RESET PRINTER, and then reminded you to set the paper type, print quality, and any Color Management settings, I assumed you would do this manually, and not try to re-use your saved JOB or saved PRINTER settings.
Right?
You have an HP printer, although I couldn't make out the model, they have a track record of changing their own driver settings on a whim, and if you saved the JOB with the whimsical settings, the problem gets loaded back in when the JOB is reloaded.

We will overcome!!!

:-)
Fred