|
Title: Landscape/portrait orientation problem Post by: ChicagoRob on November 13, 2011, 04:07:42 PM I have a file that I want to put into the print queue in landscape
orientation. As soon as it goes into the queue, it reverses to portrait mode. If I change the mode to portrait in Print Properties, the image switches to landscape mode. It always does opposite of what I want. I have no problems with any of my other files. I'm sure I'm doing something stupid, but haven't a clue on how to remedy the situation. Rob Title: Re: Landscape/portrait orientation problem Post by: Terry-M on November 13, 2011, 04:13:55 PM Hi Rob,
Just below the page preview, there is a little Padlock icon, click that to the lock the orientation. It will then match the thumbnail orientation. See screen shot attached below. Terry Title: Re: Landscape/portrait orientation problem Post by: ChicagoRob on November 13, 2011, 04:47:57 PM Hi Rob, Just below the page preview, there is a little Padlock icon, click that to the lock the orientation. It will then match the thumbnail orientation. See screen shot attached below. Terry Thanks a lot, Terry-M. Just tried your suggestion and it worked perfectly. It's strange that this particular file required the lock, but it's good to know, just in case. Rob Title: Re: Landscape/portrait orientation problem Post by: Fred A on November 13, 2011, 06:13:23 PM Quote Thanks a lot, Terry-M. Just tried your suggestion and it worked perfectly. It's strange that this particular file required the lock, but it's good to know, just in case. It depends on the aspect ratio of the image and usually on how it was cropped. Fred |