Hi Ned,

I looked this up online, and you can read about this setting in the 3880 manual if you have it on hand (Page 52):

https://files.support.epson.com/pdf/pro3880/pro3880ug.pdf

"AccuPhoto HD2 for any type of photographic printing. If you are
printing 16-bit color images, select 16 Bit Output for the most
accurate transitions and gradations."

So you would check that box if the image you are printing is 16-bit. In this case, the Qimage One pipe line is 8-bit, even for 16-bit source images. So that box should NOT be checked for use with Qimage One.

As far as resolution, use the highest resolution for printing smaller prints, where they will be viewed closer. For very large prints which will only be viewed at a distance, you can use the lower resolution settings, which will reduce processing time to print.

Andrew

For 16 bit images, both Qimage One and Qimage Ultimate produce visually identical output whether the driver is 8 or 16 bits.  It does this by intelligently dithering the 8 bit values using the 16 bit data in images so you get much higher than 8 bits/channel even with 8 bit drivers.  You can test it if you like: create any type of 16 bit gradient you want and print it in both Q1 or QU and then also print it in any application that supports "true" 16 bit printing (in Windows, you'd need a dedicated 16 bit print plugin to try this as Windows itself has an 8 bit/channel pipeline).  There will be no visible difference in the output.

Regards,
Mike

That's OK.  I'm a pixel peeper: kinda have to be.    I ran a lot of stress tests using slowly changing 16 bit gradients to make sure the 8 bit output looked the same as the specialized 16 bit driver.  The beauty of the 8+8 output vs true 16 is that Q1/QU can print smooth gradients on any driver, even with printers that don't support 16: drivers that only support 8 bits/channel.  Q1/QU is reading and making use of the 16 bits/channel, just in a little different way.

Mike