|
Title: Metric Standards for Q-Image Post by: kaisterplayer on August 23, 2009, 06:04:00 AM Dear Mike,
just a suggestion or actually a question. Very often I need to print photos to a very specific size. Also often I am told millimeters and centimeters and then I need to start this conversion business....ie. 1cm = 2.54 inches. anyway you can add a feature to add the metric sizes to the various thumpnail sizing options? thanks Title: Re: Metric Standards for Q-Image Post by: BrianPrice on August 23, 2009, 07:25:42 AM Hi
Edit>Prefernces>Units>Metric will do the trick. Brian Title: Re: Metric Standards for Q-Image Post by: Fred A on August 23, 2009, 11:51:53 AM Quote Edit>Prefernces>Units>Metric will do the trick. .... or email Brian or Terry, and they will email right back with the answer to the conversion. ;D ;D ;D ;DJust joking... Fred Title: Re: Metric Standards for Q-Image Post by: Terry-M on August 24, 2009, 11:13:29 AM Quote Very often I need to print photos to a very specific size. Just one point to add.When you change the units in Qimage, all the pre-set sizes are converted. However, any values in the Custom/Enter a specific size dialogue will remain as the original numbers and not be converted. You would have to enter the specific values for the unit system you are using. Terry. Title: Re: Metric Standards for Q-Image Post by: Ernst Dinkla on August 24, 2009, 12:57:58 PM Dear Mike, just a suggestion or actually a question. Very often I need to print photos to a very specific size. Also often I am told millimeters and centimeters and then I need to start this conversion business....ie. 1cm = 2.54 inches. anyway you can add a feature to add the metric sizes to the various thumpnail sizing options? thanks Be aware that in the Edit Page window the metric measurements are rounded off at 1 mm, the inch values are more precise there. The precision of your conversion as described above has a flaw too :-) met vriendelijke groeten, Ernst Dinkla Try: http://groups.yahoo.com/group/Wide_Inkjet_Printers/ Title: Re: Metric Standards for Q-Image Post by: Terry-M on August 24, 2009, 01:16:02 PM Quote The precision of your conversion as described above has a flaw too :-) Well spotted Ernst ;DWe'll leave the USA guys to work it out ;) Terry |