HI all I'm trying to print a panorama  on a epson R1900 printer I have tried reading the manual but no luck, wasting alot of paper. Have been trying to print a panorama shot the size of the picture is 7449 X 2253 Have tried many different ways but it dont come out right, it prints the wrong way and only part of a small section comes out. The size of the frame I have is 11 3/4 X 30 so is there a way to print a centered picture on the 13 inch roll paper, Thanks in advance

Bill

Thanks for info but do you print in portrait or landscape it printed out 3 pictures in portrait and with spaces between it..what a mess

at snap 28 it tells me page: 13.000 x 12.716 (720 x 720)

ok I have now it set to page 31.00 x 12.716 (720 x 720)

Thanks for help will let you know how it comes out

Bill,
Now that you have the hang of it, and have changed the paper size to 36.5" long and set the width to 1205, and set the driver to Borderless.
You should get an even .25 inch border around your print.
See screen snaps of the Qimage Full Page Editor screen.

If you want to use cut lines, then I would change the procedure to this routine.
1) Set the paper size to 1295 x 3700 in User Defined. Turn Off the Borderless (and remember to answer banner mode when the box pops open) .
Go back to the Qimage main page where your 36.5 x 11.75 print is set. and now make sure the image is selected by clicking on it one time, and add a .25 inch white border to the print using the B+ setting.
See screen snap 13. Now put a check mark in EDGES just below the borders boxes, and select Guidelines or whatever you like better.
That will place the cutting guidelines on the outside the .25 inch border, and you can use them easily.

Fred

Thanks Fred and seth I have the picture up on the wall as I type, but had still problems but a great learning curve. I learn that you should keep the size to what you want and not add half a inch and to add borders inside that size and some day I will figure out the cut lines. Thanks for all the help