|
Title: print length problem using Qimage on Epson 7800/9800 Post by: dave on December 10, 2010, 11:21:53 PM Hi folks...........new here and new to Qimage. I bought this product for basically one application.......that is to extend the print length
beyond the Epson parameters. I followed the instruction advice under 6a but what happened is that the printer went to the max allowed by Epson, cut the paper, then continued on for the extended length. Anyone know what I did not do properly? Thanks......... DD ( Dakota Dave) Title: Re: print length problem using Qimage on Epson 7800/9800 Post by: Fred A on December 10, 2010, 11:34:07 PM Quote followed the instruction advice under 6a but what happened is that the printer went to the max allowed by Epson, cut the paper, then continued on for the extended length. Anyone know what I did not do properly? Dave, As a rule the item most people miss is BANNER MODE in the driver. Set the User defined page size to a little larger than the print size, after you set roll paper and banner mode. Then in Qimage set your print size or multiple prints in place, and it will work. Fred |