I am trying to print a image on a paper that is 8x10 with the image having a very thin lined .03 inch black border next to the image and a 1 inch white border around the thin line black border as well as the  image itself.  I end up getting the thin black line around my image correct, but I run into trouble with the white border around it.  For some unknown reason in the Full Page editor under print location, it always has my images located with a white border of .29 inches at the top and .34 inch at the bottom.  Now when I tell it to make my 1 inch border all around the image, it makes the white border on the right and left side of of my image the 1 inch one inch border that I wish to have, but the top is 1.29 inches and the bottom is 1.34 inches.  I know that I have something set wrong, but I just cannot figure it out.  I can correctly set it up in Lightroom 4 to print the way that I wish, and with my monitor calibrated, I am liking the images that I am getting from Lightroom 4.  I would like to be able to set it up in Qimage to the 1 inch border all around, since Qimage prints my images much closer to what I want them to look like other than the border.  Any ideas as to what I have set up incorrectly in Qimage?

You got it!
All that you were seeing (and the border color was white) was the border plus the remainder of the unused paper added together,

Good job!
Fred

I have been a member on here since 2010, and have owned Qimage for quite some time longer than that.  I have yet to figure out how to work the Automatic Copyright/Signature.  I wish that there was an easier way to place your signature upon your images when printing.  I sometime print in Lightroom 4 because I need to place either a signature or a water mark on my images and it is much easier to do that in there. I just have not figured out how to do that with Qimage.  Any help on that?