Think of it like a bus schedule.  Up top in the global settings (date and repeat) you are specifying how often the bus stops at the bus stop.  Down below in the per-job cycle tuning, you click on each job and specify the first time each job takes the bus and how often.  So set it like this...

Print all listed jobs (below) at the above date/time and then repeat every (The "bus schedule: how often the bus stops at the bus stop):
1 day, 0 hours.

Then on your two jobs, set the per-job cycle tuning as follows by clicking on the job and then setting.

Per-job cycle tuning (When each job gets on the bus and how often):
Job 1:
Print on: 1st cycle
Then: Every 2 days

Job 2:
Print on: 2nd cycle
Then: Every 2 days

That way the bus stops at the bus stop every day (it has to in order to meet your requirements) and both jobs get on every 2 days, but job 1 starts on the 1st cycle so 1, 3, 5, 7... and job 2 waits until the second cycle to start so 2, 4, 6, 8....

Regards,
Mike