Hi Liz,
Mike usually waits a little while before doing the necessary processing to incorporate a new camera and does checks on images from the camera. This is to make sure there are no problems with dcraw before QU is updated.
You need an IT8 target like the one show attached below. They are not very expensive if ordered from Wolf Faust in Germany; that is where Mike gets his from for Profile Prism. He would probably sell you one too.
Once you have a target you need to e-mail Mike (DDI support) for full instructions on how to take the photograph of the target. It's not difficult but Mike's guidelines must be followed. You then send the image to Mike, he makes a profile and you get it free.
Terry

Hi Liz,
This one:
R1 - IT 8.7/2 Reflective Scanner Target on Kodak Professional paper.

Somewhere I've read that Mike will make profiles from users target images, email him direct at mchaney@ddisoftware.com for the details.
In fact I have done it very recently; I do have Profile Prism so was able to make my own but I sent the image to Mike too for him to check and make a 600D profile to add to the QU collection.
Terry