Mike Chaney's Tech Corner
November 16, 2024, 01:51:36 PM *
Welcome, Guest. Please login or register.
Did you miss your activation email?

Login with username, password and session length
News: Qimage registration expired? New lifetime licenses are only $59.99!
 
   Home   Help Login Register  
Mike Chaney's Tech Corner > Mike's Software > Qimage Ultimate > v2017.104 issues/comments
Pages: [1]
« previous next »
  Print  
Author Topic: v2017.104 issues/comments  (Read 6257 times)
admin
Administrator
Forum Superhero
*****
Posts: 4218



Email
« on: October 03, 2016, 05:24:24 PM »
http://www.ddisoftware.com/qimage-u

v2017.104   Oct 3, 2016

Priority: Low

v2017.104 fixes visibility of Live View buttons that were only partially visible on some monitors/resolutions.

Mike
Logged
Fred A
Forum Superhero
*****
Posts: 5644



WWW Email
« Reply #1 on: October 04, 2016, 09:21:17 AM »

To translate the above into a useful feature:
You need to drag the vertical separator bar to the left more and more in small cuts until the preview panel no longer responds by growing larger.
See snaps
137 shows the cursor that has changed and is ready to be dragged left
139 shows the new tabs and a change of functionality: See the Queue: See the Job properties.
138 shows the preview panel in small size when the vertical separator is too far to the right.

Enjoy.

Fresd
Logged
philelrod
Newbie
*
Posts: 4


Email
« Reply #2 on: October 12, 2016, 09:10:49 PM »
I can't seem to get a print the size as entered.  I enter the paper size and the custom print size and it shows up on the view normally, but it prints much smaller.
example is a print entered as 16.25 inches comes out as 9 1/8 ".  This just happened very recently; any chance it is due to the latest version 2017-104?
Logged
Fred A
Forum Superhero
*****
Posts: 5644



WWW Email
« Reply #3 on: October 12, 2016, 11:07:07 PM »
Quote
I can't seem to get a print the size as entered.  I enter the paper size and the custom print size and it shows up on the view normally, but it prints much smaller.
example is a print entered as 16.25 inches comes out as 9 1/8 ".  This just happened very recently; any chance it is due to the latest version 2017-104?

In 99% of the time the culprit is a check in a box that causes the driver to resize.
See attached snap, and make sure it says Output same ane input and NO checkmarks at all.

Fred
Logged
Pages: [1]
  Print  
« previous next »
 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Valid XHTML 1.0! Valid CSS!
Security updates 2022 by ddisoftware, Inc.