Previously, when trying to show you how simple and easy Qimage Ultimate makes your RAW images come to life with a minimum of fuss and sliders, we concentrated on how little you had to do and worry about.
Once again I ask that you bear with me...... wait a moment!
If these images are in Raw mode, then maybe you should bare with me.
I need to present you with a few samples that will likely need two posts to handle them.
Here we we see in Screen snap #091 and #096 two shots that Q-Ultimate decoded perfectly; keeping detail in the bright clouds, and not allowing the shadows to get too muddy either.
We had talked about the FILL slider in terms off adding fill light depending on the exposure, and I also mentioned that the Zero Fill light setting was as low as the automatic decoder would go.
Below that, you do it manually.
What I am saying is to try it... pull that FILL slider to the minus side.... see what you get; see what it changes; see how it *could* make a huge improvement to a somewhat hum-drum shot.
So let's look at screen snap #092 and 093.... 092 has a MINUS 12 Fill, and going even further, 093 has a minus 15 fill.. Probably a bit too much, but this is just a challenge!!
Look how the minus fill has changed the dynamic of the scene... added interest... (all in the eye of the beholder)
Can't add any more samples here so let's move on to the next post below. ..........................
''''''''''''''''''''''''
Don't forget to click your mouse on an image to enlarge it!
Qimage registration expired? New lifetime licenses are only $59.99!
